Programat P90 Manual - Ivoclar

involves managing essential parameters via the numeric membrane-sealed keypad and monitoring the 7-segment display. Programat press furnaces - Ivoclar

Secure all hose clamps to prevent pressure leaks during operation. 3. Programming and Operation Instructions

Use clean, high-quality firing trays and honeycomb plates. Contaminated trays can transfer impurities to your ceramic restorations.

For the P90, the only way to “update” the software is to replace the EPROM chip or the entire control board – a job that should be performed by a qualified technician.

Ivoclar Programat P90 Manual: Complete Operating & Technical Guide Ivoclar Programat P90 Manual

The peak temperature required to vitrify the ceramic matrix.

The Ivoclar Programat P90 Go to product viewer dialog for this item.

Press the specific parameter key you wish to modify (e.g., for Holding Temperature). The value on the display will flash.

Because it is a legacy model, finding an official physical copy of the can be challenging. This comprehensive guide serves as an operational and troubleshooting manual, compiling critical setup steps, programming instructions, error codes, and maintenance workflows for dental technicians. 1. Technical Specifications and Initial Setup Ivoclar Programat P90 Manual: Complete Operating & Technical

If the furnace displays a service alert, contact a qualified technician. Do not attempt to repair internal components unless authorized. Troubleshooting Guide

The P90 comes pre-loaded with 99 programs. The manual dedicates 15 pages to explaining the factory settings. Below are the three most critical cycles every user must know.

: Comes with 90 built-in programs . Standard programs (P01–P08) have some data automatically set, such as specific settings for glaze (P04) or dentin firings (P07).

| Specification | Value | |---------------|-------| | Dimensions (closed) | 415 mm × 433 mm × 295 mm | | Maximum firing temperature | 1,200 °C | | Firing chamber diameter | 90 mm | | Firing chamber height | 80 mm | | Mains voltage | 220–240 V (50/60 Hz) | | Vacuum pump | External, oil‑lubricated (typical) | | Number of programs | 90 (P01–P90) | | Year introduced | 1987 | Programming and Operation

The back of the Programat P90 manual is usually reserved for the . Here are the most common ones:

Regular maintenance prevents contamination of ceramic restorations and extends the life of the quartz tube. Daily Maintenance

Modern reviews and manuals emphasize several critical safety precautions for this model:

Initiates or aborts the selected firing program. 4. Programming and Operation