Cobra 3195 Alarm Manual Full ^new^ Site

The turn signals will flash once, and the status LED will flash slowly. Perimetric protection activates instantly; volumetric (ultrasonic) sensors calibrate over the next 30 seconds. Disarming the System

This guide is for informational purposes. Always refer to the official Cobra 3195 documentation for installation and safety procedures.

Monitors doors, boot (trunk), and bonnet (hood) via direct pin switches or the vehicle's CAN-bus/original wiring.

Once the PIN is accepted, press the large button on each remote to be paired. If your remote fails, you can disarm the system manually: Cobra Alarm Fob Programming Guide | PDF - Scribd

Open the vehicle door manually using the mechanical key. The alarm will sound. Turn the ignition . The LED on the dashboard will begin to flash. cobra 3195 alarm manual full

Every Cobra 3195 system comes with a default or installer-set 4-digit code (often found on a passcode card in the original documentation). Step-by-Step PIN Entry Let us assume your PIN code is .

The Cobra 3195 operates on a modular platform, meaning the alarm ECU (Electronic Control Unit) is housed separately from the siren, making it harder for thieves to locate and disable. Core Specifications 433.92 MHz radio frequency control.

: Features a dash-mounted LED/push-button panel for manual disarming via a unique 4-digit PIN code . Operational Guide Arming and Disarming

Press and hold the valet button on the LED panel until the LED flashes rapidly. The turn signals will flash once, and the

Are you a proud owner of a Cobra 3195 alarm system for your vehicle? Congratulations on taking the first step towards ensuring the safety and security of your prized possession. With a Cobra 3195 alarm system, you can rest assured that your vehicle is protected against theft and vandalism. However, to get the most out of your alarm system, it's essential to have a thorough understanding of its features, installation, and operation.

Press (large button) on your Cobra remote control once while the system is armed. Direction Indicators: Flash once. LED Status Indicator: Turns off completely. Siren (if configured): Beeps once. Passive Immobilization

Press the large button (A) on the remote key fob. The direction lights will flash twice to confirm the system is armed.

: If enabled, the system automatically arms 30 seconds after the ignition is switched off and the last door is closed. Always refer to the official Cobra 3195 documentation

Here are some additional tips and tricks to help you get the most out of your Cobra 3195 alarm system:

covers the 3190 series, detailing basic functions, advanced features, and emergency procedures. Wiring and Installation Cobra 3100 Fitting Instruction is available via Autoprotect

A door, the boot, or the bonnet circuit was opened.