Hw 130 Motor Control Shield For Arduino Datasheet Free //top\\

// Run at half speed analogWrite(M1_SPEED, 128); delay(2000);

Here's a simple example code to get you started:

Up to 4 bidirectional DC motors with individual 8-bit speed selection.

The speed control (PWM) pins are mapped directly to the Arduino: Controls DC Motor 1 (M1) speed PWM Pin 3: Controls DC Motor 2 (M2) speed PWM Pin 5: Controls DC Motor 3 (M3) speed PWM Pin 6: Controls DC Motor 4 (M4) speed Power Supply Configuration

The HW-130 is a dual H-Bridge motor driver shield designed for Arduino Uno, Mega, and compatible development boards. It is based on the popular driver IC. This shield allows users to drive two DC motors or one stepper motor with ease, featuring built-in current sensing and heat sinks for improved thermal performance. hw 130 motor control shield for arduino datasheet free

This design frees up the majority of your Arduino's I/O pins for other tasks like sensors and displays.

// HW 130 Motor Control Shield - Free Datasheet Example // Motor 1: Speed = D5 (PWM), Direction = D4

#Arduino #MotorControl #HW130 #Electronics #Datasheet #DIY

Even with a free datasheet, users report these issues: This shield allows users to drive two DC

The HW-130 motor control shield is a popular, budget-friendly expansion board for Arduino. It allows you to drive multiple DC motors, stepper motors, and servos simultaneously. This guide serves as an extended datasheet and technical manual to help you get your robotics projects up and running. Technical Specifications

Just picked up an HW-130 Motor Control Shield for an upcoming robotics project. It’s a great, cheap shield for driving two DC motors (or one stepper) based on the L298P driver.

is a dual-channel motor driver shield designed to plug directly onto an Arduino UNO, Mega, or Duemilanove. It is based on the robust .

if (cmd == 'F') // Forward motor1.run(FORWARD); motor2.run(FORWARD); else if (cmd == 'B') // Backward motor1.run(BACKWARD); motor2.run(BACKWARD); else if (cmd == 'S') // Stop motor1.run(RELEASE); motor2.run(RELEASE); It allows you to drive multiple DC motors,

I can provide a or a complete code sketch for your specific robot!

The L293D chips can get hot when drawing close to 600mA continuous current [1]. Consider sticking mini aluminum heatsinks onto the chip surfaces if you run heavy loads.

| HW-130 Function | Arduino Pin | |------------------------|-------------| | Motor A Direction 1 | D8 | | Motor A Direction 2 | D9 | | Motor A Enable (PWM) | D10 | | Motor B Direction 1 | D11 | | Motor B Direction 2 | D12 | | Motor B Enable (PWM) | D13 | | External Power Input | Vin (or separate terminal) | | GND | GND |

The shield acts as an interface between the low-power logic of an Arduino and the higher-power requirements of motors. : Utilizes two motor driver chips and one shift register. Motor Capacity : Can drive up to 4 bi-directional DC motors 2 stepper motors (unipolar or bipolar). Servo Support : Features 2 dedicated connections