Manual ((hot)) | Cwfl-6000
The ambient sensor is disconnected or damaged. Replace the sensor probe.
The CWFL-6000 manual reveals a robust machine, but one that demands respect for its dual-circuit logic and maintenance needs. If you treat the water quality with care and keep the condenser clean, this unit is built to handle 24/7 industrial laser cooling.
Locate parameter (Control Mode): Change from 1 (Intelligent) to 0 (Constant).
Maintain a minimum clearance of 1 meter (3.3 feet) from the air outlet (top exhaust fans) and at least 50 centimeters (20 inches) around the side air inlets.
Connect the 3-phase power lines and the ground wire securely to the internal terminal block. cwfl-6000 manual
Usually occurs in winter. Add a chiller heater or adjust ambient space. Room Temp Sensor Failure Open or short circuit in the ambient sensor. Inspect sensor wiring or replace the ambient sensor probe. E5 Water Temp Sensor Failure Main water loop temperature sensor failed. Inspect or replace the water temperature sensor probe. E6 Water Flow Alarm Water level is low, or there is an external hose kink.
start the chiller without water in the tank. Fill it until the gauge hits the green area 3-Phase Check: If you see error codes E08 or E09
By default, it uses an Intelligent Control Mode (T-803 controller) which adjusts water temperature based on ambient room temperature. 🛠️ Maintenance & Troubleshooting CWFL-6000 Manual - 20230104094939 | PDF - Scribd
Generally configured for 3-phase 380V (50Hz/60Hz) or 3-phase 460V, depending on your regional manufacturing model. Always check the physical nameplate on the side of the unit. Refrigerant Type: Eco-friendly R-410a. The ambient sensor is disconnected or damaged
If your chiller starts beeping, check the display for these standard codes found in the : E1 Ultrahigh room temperature Improve ventilation or lower room temp. E2 Ultrahigh water temperature Check for clogged dust gauze or pump failure. E3 Ultralow water temperature Normal in winter; use a heater if necessary. E4 Room temp sensor failure Inspect sensor wiring or replace sensor. E5 Water temp sensor failure Check the probe connection. E6 Water flow alarm Check for kinked hoses or low water levels. 🧹 Maintenance Schedule
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
To extend the lifespan of your 6000W laser system, adhere strictly to this maintenance routine:
This comprehensive guide serves as an operational manual, technical reference, and maintenance blueprint for operators managing the CWFL-6000 cooling unit. 1. Technical Specifications Overview If you treat the water quality with care
Up to 14kW to 14.4kW (depending on operating conditions)
Routine maintenance prevents costly downtime and keeps your 6kW fiber laser running at peak efficiency.
The Teyu S&A CWFL-6000 is a high-capacity dual-circuit industrial water chiller. It is specifically engineered to cool 6kW (6000W) fiber laser cutting and welding systems. By managing the temperature of both the laser source and the optics independently, this chiller prevents thermal degradation and ensures consistent laser output.
Check the water level gauge to ensure the fluid remains in the green zone.
