security systems. It features an IP67 rating, making it suitable for wet or dusty environments, and supports a maximum LAN distance of 1.5 km. aritech.com.au Draft Installation Guide: Tecom TS1162 1. Pre-Installation Requirements
The printhead has exceeded its safe operating temperature. Turn off the printer and allow it to cool down. Reduce print speed or darkness settings in your driver. Common Issues and Quick Fixes Issue: Printer skips labels or prints blank pages : Incorrect sensor calibration or driver settings.
: Remove the body retaining screws from the bottom of the unit and pull the body away from the base.
If your unit features a digital display or network interface, follow the on-screen prompts to set your language, time zone, and system parameters. 6. Maintenance and Troubleshooting
: Connect a standard push-button or sensor to the designated input for door release. Door Control ts1162 installation manual
The TS1162 supports both Direct Thermal (no ribbon required) and Thermal Transfer (ribbon required) printing styles. Loading Label Rolls
The is a highly durable, industrial-grade access control keypad designed to integrate seamlessly into a Tecom Challenger commercial security infrastructure. Engineered to withstand harsh deployment scenarios, it features a ruggedized molded plastic housing and boasts an IP67 environmental protection rating , making it perfectly suited for dusty, wet, or exposed outdoor locations.
Wipe the rubber platen roller while manually rotating it to clear any stuck paper dust or glue.
The TS1162 is typically configured using the CTPlus software. For specific programming options, please consult the full ChallengerPlus programming manual. A few key points to keep in mind during programming: security systems
Inspect terminal connections annually for tightness and signs of wear. Troubleshooting Common Issues Possible Cause Recommended Solution Circuit breaker is tripped Reset the circuit breaker. Loose terminal wiring Turn off power and check all wire connections. Intermittent Operation Supply voltage fluctuations Verify voltage with a digital multimeter. Overheating Ensure ventilation paths are clear of obstructions. Error Indicator Flashing System self-test fault Cycle the power off for 30 seconds, then restart.
Should you encounter problems, here are some common issues and their solutions:
: The Challenger Series Installation Manual provides general wiring and mounting instructions applicable to RAS devices like the TS1162.
The keypad requires a DC power source within this range, typically supplied by the main security panel. Connect the positive (+) and negative (-) power leads to the corresponding terminals on the keypad’s pigtail cable and to the power output terminals on the Challenger panel. Common Issues and Quick Fixes Issue: Printer skips
:
The keypad’s address is configured directly via its own keypad interface. Consult your main panel’s programming guide for the specific procedure on how to enter programming mode from the keypad to set its unique bus address. Once set, the main controller should automatically detect the keypad if its model is present in the system's device list. The Tecom TS1066 programming manual notes that if the model number (TS1162) is not auto-detected, you may need to manually select it from the system's list.
Observe the front panel indicator lights. A solid green light typically indicates normal power delivery.
| Code | Meaning | Fix | |------|---------|-----| | E01 | Temp probe short | Replace probe | | E02 | RH sensor stuck | Desiccate for 24 hrs | | E07 | CO2 reading >3000 ppm | Vent room, re-zero | | E14 | Relay 1 welded | Replace relay board | | E99 | Firmware corruption | USB reflash (see Appendix C) |
To help provide the most accurate instructions, please tell me your TS1162 is (e.g., a thermostat, access control panel, or fuel pump). Once you share that, I can give you the exact wiring schematics and programming steps for your specific model. Share public link