Secure the upright vertical posts to the base frame. Do not tighten the bolts fully until the frame is fully assembled to allow for alignment. Step 2: Weight Stack and Seat Assembly
Dual Trac 20 Product Code: DPTR20 Document Type: Home Assembly & User Guide
While some basic tools may be included in the packaging, having the following high-quality tools on hand will make assembly much smoother: Two adjustable wrenches (or a metric socket set) Phillips head and flathead screwdrivers Allen (hex) wrench set Rubber mallet (for tapping caps and bolts into place) Silicone lubricant spray (for the weight guide rods) 3. Inventory the Parts
If you are assembling the unit without a full step-by-step diagram, follow these general industry practices for DP equipment: Identify the Model:
Grease the guide rods and "trac" lines before sliding on your weight stack or carriage to avoid immediate metal-on-metal friction. Browse Cable Assemblies - dp fit for life dual trac 20 Dp Dual Trac 20 Assembly Manual
Ensure the nylon washers are present at the pivot point; these act as spacers to keep the bench centered.
Here is a general assembly framework. Please use this as a guide in the absence of your specific manual:
Thread on the washers and hex nuts by hand. Do not wrench-tighten yet.
The Lifestyler 15666-Dual Track 20 is a multi-functional weight and exercise system. Before unboxing all the components, it helps to understand the anatomy of the machine. The build is generally broken down into several distinct modular assemblies: Secure the upright vertical posts to the base frame
Based on assembly reviews and manual instructions, the process typically requires specific tools and attention to structural stability: Initial Setup & Stabilization
Attach the to the base frame using two long carriage bolts, washers, and hex nuts.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Fitness Gear Assembly DIY Step By Step Guide
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Inventory the Parts If you are assembling the
Ensure the cables sit deep in the "V" groove of every pulley. 5. Phase 4: Final Safety Check
Test the range of motion. Sit on the bench and cycle through the butterfly/press arms to ensure movement is fluid and the cables/weights (if applicable) engage properly. Important Safety and Maintenance Tips
Use the included multi-hex tool on the rear roller bolts.