If your 22.3.1 clone stops working or displays a "License Revoked" message, try these repair steps:
Plug the HEX-V2 clone into your laptop and your vehicle.
Right-click it, choose , select Browse my computer for drivers , and point it to C:\Ross-Tech\VCDS\Drivers\ . Step 4: First Run Options and Port Testing Double-click your desktop VCDS Loader shortcut. Once the application opens, click on the Options button. Under "Port Selection", select USB . Click the Test button.
If the issue persists on older versions of Windows or you cannot disable Core Isolation, try these alternative methods:
If your cable was accidentally exposed to the internet, or if you accidentally updated the software, your clone will likely become "bricked." Symptoms include a "Port Does Not Exist" error, an "Interface Not Found" error, or the status changing to "Unregistered/Blocked." Scenario A: Interface Not Found (Driver Issues) vcds 2231 hex v2 clone repair install
If you are experiencing a specific error (e.g., "License Revoked" or "USB Library Error"), please describe: on the cable (red, blue, or both)? What version of the loader you are using? Did you accidentally connect to the internet ?
Reason: The operating system is failing to detect the cable hardware, or the logic chip lacks sufficient operating power.
: If a prompt appears inside VCDS stating a newer software version is available, always click Cancel .
: Before starting, disable all antivirus software (including Windows Defender) and disconnect from the internet . Antivirus programs often delete the critical loader files needed for clones. If your 22
Locate the interface under "Universal Serial Bus Controllers" or "Other Devices".
Recent updates to Windows 11 have changed driver enforcement policies, which can prevent VCDS interfaces from loading correctly. Fortunately, there are several proven workarounds:
Plug the cable into your car's OBD-II port and turn the ignition
Here’s the interesting part: you can fix it, but only if you understand clones fail. Once the application opens, click on the Options button
Click on Options within the main menu. Select USB as your port type and click Test .
Once the firmware is repaired, you need to install the software and drivers correctly to avoid immediate re-locking.
Plug the ST-Link into your computer's USB drive slot. Open the STM32 ST-LINK Utility program and click the Connect to Target icon.
What or LED behavior is your device currently showing? Which Windows operating system version are you running? Share public link
Set the correct fuse bits to unlock the chip (Standard Clone Fuse configuration: Low Fuse: 0xCD , High Fuse: 0x19 , Extended Fuse: 0xFF ). Click , followed by Write Flash and Write EEPROM .
If your cable shows a "License Revoked" error or is no longer recognized, it may have been deactivated by an official update.