Galaxy Aqua Premier Installation Manual -

The Galaxy Aqua Premier typically features clear INLET and OUTLET ports.

A 30mA RCD must be installed in the circuit.

Cut the existing water line to allow for insertion of the new unit. Apply Tape: Apply Teflon tape to all threaded connections.

Minimum running pressure of 1.0 bar (14.5 psi) is required.

Reconnect the flexible riser tube to the top of the adapter valve. Step 2: Install the Drain Saddle galaxy aqua premier installation manual

Let water run through the faucet for 10 to 15 minutes to purge air pockets and flush the carbon filters. The water may look dark or cloudy initially; this is normal.

Position near a cold water supply line. Do not connect the system to a hot water line.

Ensure all quick-connect fittings are secure. If needed, use locking clips. Step 7: System Startup and Testing

Reconnect the flexible faucet riser hose to the top of the adapter valve. The Galaxy Aqua Premier typically features clear INLET

Let the storage tank fill completely, then empty it. This may take 1-2 hours depending on water pressure. 📋 Maintenance Checklist To keep your Galaxy Aqua Premier working efficiently:

Identify a straight section on the vertical or horizontal drain pipe above the p-trap.

To help clarify any specific parts of your installation setup, let me know: Is your system a model?

Are you planning to connect the system to an ? Apply Tape: Apply Teflon tape to all threaded connections

The Galaxy Aqua Premier utilizes quick-connect fittings. To connect a tube, cut it squarely, push it into the fitting until it bottoms out, and pull back gently to ensure a secure lock. Tubing Color Source Connection Destination Connection Feed Water Adapter Valve Pre-Filter Inlet Red Main System Drain Flow Restrictor Drain Saddle Valve Blue System Post-Filter Outlet Designer Chrome Faucet Yellow System Storage Tee Water Storage Tank Ball Valve 5. System Startup and Flushing

Follow these sequential steps to install your Galaxy Aqua Premier system. Step 1: Shut Off the Water Supply

Connect the Pure Water port on the unit to the bottom of the faucet shaft using the provided compression fitting or quick-connector. Step 6: System Startup and Flushing Procedure