Altiumr To Xpeditionr Translator | User Guide Exclusive

Most basic translators (e.g., ODB++, PADS) ignore parametric logic or require post-migration manual cleanup. The Altium-to-Xpedition guide emphasizes this as a time-saving, design-intent preserving feature that competitive translators (like Altium-to-Allegro or generic IDF) do not document.

: After translation, it's crucial to verify the design in Xpedition. This includes checking the schematic, layout, and netlist for accuracy. Some manual adjustments might be necessary due to differences in how tools interpret design rules and constraints.

Altium to Xpedition Translator User Guide: Exclusive Migration Insights

Verify total board dimensions and target mounting hole locations. altiumr to xpeditionr translator user guide exclusive

The translator does a 90% job on physical constraints (clearance, width) but a 40% job on electrical constraints (differential pairs, matched lengths).

No translation is entirely "hands-off." Engineers must be prepared to troubleshoot the following common scenarios:

A successful migration depends on building an Xpedition from your legacy Altium components. Component Symbol Translation Most basic translators (e

Verify the board outline coordinates, mounting hole placements, and critical connector positions against the original Altium mechanical output. 3. Design Rule Check (DRC) Matrix Setup

A successful layout migration relies entirely on a clean Central Library ( .lmc ). Translate the libraries before attempting to convert the design files. Step 1: Initialize the Central Library Open the .

[Altium Project] ──> [Export ASCII / Schematics] ──> [Xpedition Data Import Wizard] ──> [Central Library Linking] Step 1: Exporting Source Data from Altium This includes checking the schematic, layout, and netlist

Initialize the padstack and symbol partitions where the translator will deposit incoming assets. Step 3: Executing the Xpedition Data Import Wizard

The full, "exclusive" version of the user guide and the necessary configuration files are typically restricted to registered users.

For the exact workflow, refer to the Siemens Support Center document: – Section 4.3 (“Parameter Mapping”) and Section 5.2 (“Conditional Cell Assignment”).

: In Xpedition, use the Project Migration Wizard . For some configurations, such as PADS Professional, the translator may be located in the installation directory under SDD_HOME\common\win32\bin\mglaunch.exe if not visible in the start menu. Schematic Conversion : Point the translator to the Altium schematic files.

To get the most out of the Altium to Xpedition translator, follow these best practices: