Lifetime Basketball Hoop Assembly Cb14500: 2021

Fix the lower and upper extension arms to the top pole section while the pole is still lying horizontally on the ground.

The foundation of your basketball hoop relies on a rigid vertical pole. The CB14500 features a three-piece pole system that must be driven together permanently.

: To permanently lock the sections together, lift the combined pole assembly vertically and strike the bottom end firmly against a thick piece of scrap wood or heavy cardboard 5 to 6 times. Flip the pole over and strike the opposite end against the wood. This structural friction-fit creates a stable, wiggle-free foundation.

Is your specific system a with a plastic wheel base, or an in-ground model requiring concrete?

: Scrap wood or thick cardboard to protect the poles during the "seating" process. Stabilization lifetime basketball hoop assembly cb14500

(2) 7/16”, (2) 1/2”, (2) 9/16”, (2) 3/4”, and (1) 3/8”

Phillips screwdriver, pliers, rubber mallet, and a 3/16” Allen wrench

It lowers the barrier to entry for fitness. It democratizes fun across age groups. And it solves the perennial parent problem: "I’m bored."

The base provides the foundational stability for the entire structure. Fix the lower and upper extension arms to

Open all boxes and group hardware by the numbering system in the manual. Do not mix the bolts.

Sand is heavier than water per volume, providing superior stability. It cannot leak or freeze.

Measure the total length of the combined poles with your tape measure to confirm they have seated completely. Once they are fully seated, drive the provided self-tapping screws into the designated connection points to lock the poles permanently. Step 3: Backboard and Rim Assembly

Do not attempt this alone. You will need at least two, preferably three, capable adults for the heavy lifting, particularly when raising the pole. : To permanently lock the sections together, lift

This model usually uses a "telescoping" height adjustment (a pin system) rather than the expensive pneumatic gas spring found on higher-end models.

Follow the diagram closely for the spring installation. These springs are under tension, so use caution and ensure they are hooked securely. This system allows you to adjust the rim height from 7.5 to 10 feet with one hand. Step 5: Backboard and Rim Attachment This is the most labor-intensive part of the build.

: Approximately 362 lbs of sand or a water supply to fill the base. Step-by-Step Assembly Overview Portable Basketball Hoop Assembly Guide - Lifetime