This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Clicking noise from the extruder motor, gaps in print layers, or no filament extruding.
Perform a "Cold Pull" (Atomic Pull). Heat the nozzle to 250°C, push in a piece of nylon or PLA filament, drop the temperature to 90°C, and pull the filament out quickly. This removes burnt residue from the internal nozzle cavity. Issue 2: Inactive Nozzle Dragging or Oozing
QIDI is known for responsive customer service. The manual includes direct email contacts: qidi x-pro manual
In QIDI Print, each part can be assigned to the left or right nozzle. In Cura with the setQidiExtruder post‑processing script, check the box to activate the right extruder, or leave it unchecked to use the left extruder.
(Invoking related search terms for further refinement.)
The idle nozzle stays hot and gravity pulls molten plastic out. This public link is valid for 7 days
Your QIDI X-Pro should arrive mostly pre-assembled. The unboxing process typically involves:
Yes. The X‑Pro has a USB‑B port that can connect to a Raspberry Pi running OctoPrint. You will need a USB cable (printer to Pi). Once connected, OctoPrint gives you remote monitoring, webcam support, and advanced G‑code control. The SimplyPrint setup guide for “classic printers” applies directly to the X‑Pro.
: Clean the build plate with IPA (Isopropyl Alcohol) or soap and water. For stubborn prints, a thin layer of glue stick works well. Can’t copy the link right now
Feed the filament guide tubes from the back into the top of the extruder assembly. On the touchscreen, select > Load .
It is highly recommended to level the bed before long prints or if you notice adhesion issues.
Insert the two metal spool holders into the slots located on the back panel of the printer. Secure them using the provided thumbscrews.
Check the tension of your X and Y axis belts. They should be taut like a guitar string. Inspect the grub screws on the stepper motor pulleys to ensure they are tight. If youPlease let me know: What material you are currently trying to print with? What slicing software you prefer to use?
The printer will homing all axes, and the nozzle will move to the first leveling point.