Gunnebo Speedstile Fl Installation Manual _best_ <Windows Trusted>

What (RFID, biometric, barcode) are you integrating?

All external inputs route directly to the main terminal board in the Master cabinet:

Contains the primary logic controller, power supply, and user interface connections.

Route these cables through the designated low-voltage conduits. Keep them separate from AC power lines to avoid electromagnetic interference. 6. Access Control Integration

Maintain a minimum 50mm clearance between the outer chassis and any fixed walls or architectural obstacles. gunnebo speedstile fl installation manual

Torque the anchor bolts to the manufacturer’s specification (typically Step 3: Installing the Glass Wings

Locate the main microprocessor controller board inside the master cabinet. The digital inputs are opto-isolated and require a clean, dry contact (voltage-free) signal to trigger.

Do not install directly on floating floors or unsecured tiles. Electrical and Data Conduit Layout

: The finished floor must be flat and level within ± 5mm . What (RFID, biometric, barcode) are you integrating

Inspect the glass leaf clamping mechanisms for signs of loosening or friction wear.

Manually push the wings to verify they move freely without rubbing against the cabinet structure. 6. Commissioning and Calibration

, comprehensive site preparation is necessary. The unit must be installed on a finished, flat, and level floor to ensure the glass panels operate smoothly and align correctly Structural Integrity:

Before unboxing the equipment, ensure the installation site meets all environmental, structural, and electrical prerequisites. Structural Requirements Keep them separate from AC power lines to

: Units must be perfectly parallel and correctly aligned to operate properly. 2. Mechanical & Electrical Specifications SpeedStile FL

The of your SpeedStile FL (e.g., FL, FLs, BA, EV) The type of access control system you are integrating Any error codes showing on the main control board

: Minimum concrete base dimensions are typically deep, depending on the cabinet length.

Check all wiring terminal blocks for loose screw connections caused by building vibration.

Tighten the clamping bolts evenly in a cross pattern to a torque of

Installation O peration and Maintenance Manual - Siel Invest