Audiosonic Caa-09169 Clock Radio Manual Work |verified|
Digital clock radios remain highly dependable bedside companions, but losing the physical instruction booklet often turns simple tasks like adjusting for daylight saving time or disabling a weekend alarm into a frustrating puzzle. The Audiosonic CAA-09169 Clock Radio
for two seconds until the program number flashes, then press again to save. Recalling Presets:
Press the On/Off button to stop the alarm for the day. To disable it completely, move the alarm switch to the Off position. Radio Operation Power: Press the On/Off button to turn on the radio.
Your radio's controls are likely arranged on the top or front of the unit. Here are the common buttons you'll find: Audiosonic Caa-09169 Clock Radio Manual WORK
Open the battery compartment hatch located on the bottom base of the device.
supports both AM and FM bands. To optimize your listening experience:
When the alarm sounds, press the Snooze button to silence it for approximately 9 minutes . To disable it completely, move the alarm switch
Release the primary button to save the alarm coordinates firmly into the integrated memory chip. Choosing Your Wake-Up Source
When you first connect the unit to a power source, the display will flash "0:00". To set the correct time:
Repeatedly press the alarm button to toggle between waking up to the (indicator 15) or the (indicator 14). Stop/Snooze: When the alarm goes off, press the button for a 9-minute delay, or the button to turn it off until the next day. 3. Radio and Presets button to turn the radio on. Use the selector to choose AM or FM. Saving Stations: Once tuned to a station you like, press and hold Here are the common buttons you'll find: Open
The device uses a built-in directional ferrite antenna. If the AM reception is weak, physically rotate or reposition the entire clock radio unit until the signal clarifies. Setting and Operating the Alarms
Press the CLOCK/TIME SET or MEM/M+ button again to confirm. AUDIOSONIC Device Database
While holding the button, press the HOUR button repeatedly until the correct hour appears.