Zte F689 Bridge Mode Exclusive
: The existing connection is likely in "Route" mode (handling PPPoE or DHCP). To configure bridge mode, you must delete or disable this connection.
The ISP MAC address cache is locked onto your old PC setup instead of the new router.
Input the exact noted in Step 2 if the field clears.
The ZTE F689 is a capable piece of hardware, but it is a victim of carrier lockdowns. If Method 1 and 2 fail, Method 3 (ISP intervention) is your guaranteed path to a clean network topology. zte f689 bridge mode exclusive
Navigate to the submenu within the WAN settings. Locate your new bridge profile.
I can provide the exact WAN settings needed for your specific router setup.
If you lose access to the interface, hold the physical Reset button for 10 seconds to revert to ISP factory defaults. π Finalizing Your Setup : The existing connection is likely in "Route"
Under the port binding options, check the box next to (or whichever port you intend to connect to your personal router). This binds the bridged WAN connection exclusively to that physical port. Click Modify or Apply to save the changes.
Ensure the matches the original settings (usually set to Tag with your specific VLAN ID entered). Click Modify , Save , or Apply at the bottom of the page. Step 4: Bind the LAN Port
Uncheck and click Save . This prevents the ZTE F689 from assigns IP addresses. Navigate to Network > WLAN > WLAN Basic . Input the exact noted in Step 2 if the field clears
With the ZTE F689 acting as a silent bridge, it is time to set up your primary routing hardware.
: He navigated to the WAN configuration. There, hidden under a CSS "hidden" tag, was the mode profile. The Connection
Connect that Ethernet cable from of the ZTE F689 to the WAN (Internet) Port of your new router.
If your ISP uses PPPoE connection types, locate your network username and password. You will need to input these details into your new router.
Reboot both devices. If that fails, double-check your PPPoE credentials or VLAN ID settings on the new router. Some ISPs tie your connection to the MAC address of the original router; you may need to use your new router's "MAC Clone" feature to mimic the ZTE F689's WAN MAC address.