Forces the clock to immediately search for the radio atomic signal.
Place one fresh 1.5V AA alkaline battery into the compartment. Wait: Hands will fast-forward and stop at 12:00 .
Is the clock , or are the hands spinning continuously?
Once the hands park themselves at the index position, the clock stops moving and enters signal reception mode. It will remain completely still while searching for the atomic radio tower broadcast. This process can take anywhere from . Do not touch any buttons or move the clock during this window. Step 4: Time Synchronization ch899 chouchin radio controlled clock instructions free
For a visual guide, you can download a free PDF version of these instructions from our website. Simply visit our support page, enter your model number (CH899), and click on the "Download" link.
The "CH899" or "CH-899" is typically the internal (the engine of the clock), often manufactured by a company called Chouchin . You'll often see "chouchin" or "CHOUCHIN" printed on the back of the clock, indicating the movement brand, rather than the brand of the clock itself. This is a critical detail because it means that many clocks from different brands (like Weltbild, Lemnos, or STAYONE) share the same core radio-controlled technology and operational logic. Because the CH899 movement is widely used, the instructions for one are often directly applicable to another.
Press and hold the M. SET button for approximately 3 seconds . Adjust Time: Single Press: Advances the time by one minute. Forces the clock to immediately search for the
Place the clock near a window, ideally away from electronic devices (TVs, computers, microwaves) which can interfere with the signal. Allow the clock to sit undisturbed for .
Once the battery is installed, the hands will usually move rapidly to the 12:00 position and stop. This is normal. The clock is now in "searching" mode. Step 2: Automatic Signal Reception
If you live in a concrete building or are far from the radio source, place the clock near a window overnight, as signals are stronger at night. Is the clock , or are the hands spinning continuously
Are you setting up your in a location with lots of electronics or thick walls that might be blocking the signal ? The Clock Depot Radio Controlled Analog Clock Instructions
If the clock is showing the wrong time and you want to try syncing again without pulling the battery: Press and hold the (or Wave) button for 3 seconds.
Once the battery is in, the hands will quickly advance and stop at 12:00 . The clock will then search for the radio signal, which can take anywhere from a few minutes up to a few days depending on signal strength.
switch to "ON" if you want the clock to adjust for Daylight Savings automatically. Insert Battery : Place one fresh AA alkaline battery into the compartment, observing the correct polarity (+/-). Synchronization Phase : The hands will quickly advance to the 12:00 position and stop. The clock will now search for the radio signal. : Signal reception typically takes 3 to 15 minutes
If the radio signal is weak or you are outside the transmitter's range, you can set it manually: