8liech-sc-ssd - Viva Water Dispenser Manual

For most Viva SC-style dispensers:

| Function | Action | |----------|--------| | | Push the blue button or lever. | | Hot water | Push the red button (child lock must be released first). | | Child lock | Slide or turn the small switch near the red button to unlock. | | Heating | Red indicator light ON when heating. Light OFF = ready. | | Cooling | Green indicator light ON when compressor running. |

Remove the cap and insert the probe assembly into the bottle.

. Wait about one hour after the first plug-in for full cooling. Self-Cleaning viva water dispenser manual 8liech-sc-ssd

If the unit was transported on its side, you must leave it standing upright and turned OFF for at least 4 hours before plugging it in to allow the compressor oils to settle.

: Before plugging it in, depress the hot and cold levers until water flows steadily. This prevents the heating tank from dry-firing.

Toggle the hot switch (usually red) to ON. The hot indicator light will shine. For most Viva SC-style dispensers: | Function |

Proper placement is critical for the unit's longevity and performance.

: Keep the unit in a cool, shaded indoor location away from direct sunlight and explosive fumes.

A: Make sure the unit is not in direct sunlight, and the back vents have 4+ inches of clearance. | | Heating | Red indicator light ON when heating

Even with the auto-clean feature, the dispenser needs manual cleaning to prevent hard water deposits and stains, as recommended in Brio Water Cleaning Tips . Remove the tray and wash with mild detergent. Exterior: Wipe with a damp, soft cloth. Internal Tank Cleaning (Every 3-4 Months): Unplug the unit. Remove the bottle and drain all water My Health Alberta .

| Model | 8LIECH-SC-SSD | |-------|----------------| | Voltage | 110–120V / 220–240V (check local rating) | | Frequency | 50/60 Hz | | Heating power | 500 W | | Cooling power | 85 W | | Hot tank capacity | 1.0 L | | Cold tank capacity | 1.5 L | | Bottle type | 3 or 5 gallon bottom-load |

Follow these steps to ensure your unit functions correctly from day one. 1. Placement Place the dispenser on a hard, level surface. Keep it in a cool, shaded area away from direct sunlight.

Place the dispenser on a hard, flat, level surface. Leave at least 4 inches of open clearance on the back and both sides. This permits adequate airflow for the internal cooling compressor.