Rok Power Washer Instructions Patched -

Turn the power switch to the or 0 position (or turn off the petrol engine switch). Shut off the household water tap completely.

Hold the trigger until water flows out of the nozzle in a steady, continuous stream with no sputtering. 3. How to Start and Operate Your ROK Power Washer

Before turning on the power, you must remove air from the system to prevent damage to the pump.

Proper assembly and water connection prevent air locks and pump burnout. Follow these steps in order before turning the machine on. Connect the Water Supply

Buried on page 12 of the manual: "Check oil level." The factory oil is shipping preservative, not lubricant. rok power washer instructions

Snap the spray gun holder and nozzle cradle into their designated positions on the frame. Step 2: Connect the Spray Gun and Wand

Ensure your garden hose delivers at least 5 gallons per minute (GPM) at a steady pressure. Low water flow starves the pump, causing permanent internal damage.

Pinpoint, highly concentrated stream. Avoid using on wood, vehicles, or siding; it can easily gouge surfaces. Use only on concrete or metal for rust and baked-on mud.

For Rock&Rocker models, you can contact their customer support directly. For a ROK-stamped Stihl model, you can find parts diagrams and order replacements online through specialized retailers that carry Stihl equipment. Turn the power switch to the or 0

Are you currently trying to ? Share public link

Turn off the main water supply at the outdoor tap.

Squeeze the trigger on the gun . Let the water run through until a steady stream flows from the nozzle. This purges air from the pump. Release the trigger and engage the safety lock. B. Starting the Power Washer For Electric Models: Plug in the unit. Turn the switch to the "ON" (I) position.

ROK Power Washer Instructions: A Comprehensive Guide to Usage and Maintenance Follow these steps in order before turning the machine on

Page 7 — Technical analysis & environmental considerations

: With the motor in the "OFF" position, squeeze the trigger for about 30–60 seconds until a steady stream of water flows without sputtering.

Inspect the rubber O-rings inside the high-pressure hose ends and the lance connections. Replace any cracked, flattened, or missing O-rings to restore a watertight seal. If you need help with a specific issue, tell me: The model number of your ROK power washer Whether it is electric or petrol-powered